11
Save Marine, a division of
Save innovations
3 rue des arts et métiers, 38000 Grenoble, France I +33 (0)4 58 00 34 66 I [email protected]
4.2
Installation of the through-hull and inner cable
Only after completing the necessary verifications and pre-installation checklist.
1- Drill the center hole with a hole saw Ø30.
Such a diameter is needed for routing of
the inner cable and its connector
(already fixed to the through-hull).
2- Route the inner cable through the Ø30
hole.
3- Drill 4 holes with a Ø6 drill. Use the
through-hole as a template to mark the
4 holes for fixation.
4- Put sealing paste around the screw holes
on the through-hull.
5- Flatten the through-hull against the
transom and insert the 4 screws M5x25.
6- Inside the boat, the insert M5 washers
on the M5x25 screws.
Screw the NYLSTOP M5 nuts on the
M5x25 screws
7- Clean surplus of sealing paste.
