32
EQJW146F002 EN
Start-up
3.3 Changing parameters
Depending on the system code number selected and the activated functions, not all parame-
ters listed in section 13.2 might be available.
Turn the rotary switch to (settings).
q
Enter the currently valid key number.
¼
Confirm key number.
q
Select the required parameter level:
– PA1: Heating circuit HC1
– PA2: Heating circuit HC2
– PA3: Not applicable
– PA4: DHW heating
– PA5: Not applicable
– PA6: Modbus communication
Î
Only those parameter levels are available for selection
which can be controlled by the selected system.
¼
Open parameter level.
The first parameter is selected (marked gray).
q
Select parameter.
¼
Activate editing mode for the parameter.
The current setting is shown inverted on the display.
q
Set the parameter.
¼
Confirm setting.
¼
Proceed in the same manner to change further parame-
ters.
