SATEL INTEGRA
Plus
25
- button saves the time in the control panel, based on the computer clock.
- the button writes data into the control panel FLASH memory.
- button displays a virtual keypad.
- the button opens the drop-down menu, which makes available some tools to
supervise the system state.
- the button opens the „Configuration” window, if the program does not
communicate with the control panel, or communicates with it through COM port or
modem. Otherwise, the current connection (TCP/IP, GPRS) window will open.
Opening the "Configuration" window will close the COM port, which was previously
selected for communication. Closing the window will open the COM port.
- button opens the drop-down menu, where you can select the method of
establishing communication between the program and the alarm control panel.
2.2.2 Communication identifiers
The D
LOAD
X program will establish communication with the control panel if:
– the communication identifiers in the control panel have their factory default value – the
program will suggest then randomly generated identifiers (which you can accept or
enter your own ones);
– the communication identifiers in the program and in the control panel are identical.
The identifiers can be programmed:
using the keypad, in the service mode, in the SM
SETTINGS
submenu;
using the D
LOAD
X program, in the "Identifiers and tel. no" window (the command for
opening this window is available in the C
OMMUNICATION
menu; you can also use the Ctrl+R
key combination).
Integra identifier
– identifier of the alarm control panel. It must consist of 10 characters
(digits or letters from A to F). It makes it possible to recognize the control panel and match
a data file to it, if the data file has been saved on the computer. Do not program the same
identifier for different control panels which are operated from the same computer (the
D
LOAD
X program will be incapable of distinguishing between them).
D
LOAD
X
identifier
– identifier of the computer with D
LOAD
X program. It must consist of 10
characters (digits or letters from A to F). The control panel will only establish connection
with the program which uses the valid identifier.
2.2.3 Starting local programming
1. Connect the control panel RS-232 or USB port to the computer port (for the connection
method please refer to the I
NSTALLER MANUAL
).
2. Start the D
LOAD
X program and click on the
button. A window will open in which you
should select the computer port to which the control panel is connected. Press "OK".
3. On the LCD keypad connected to the control panel, enter the
service code
(by default
12345) and press the key.
4. Using the
or
key, find the D
OWNLOADING
submenu and press the or
key.
5. When the arrow indicates the S
TART
DWNL-RS
function, press the or
key.