50
SATEL
ACCO
In order to block the door by using the code and ACCO-SCR-BG reader, do the following:
1. Make sure that the door operates in normal mode and the door is closed.
2. Enter the code and confirm with the
key. 2 short beeps will confirm that the door is
blocked.
7.2.2 Blocking the door without user identification procedure
The door can be blocked by using the module input programmed as D
OOR BLOCKING
or
A
LARM
–
BLOCK DOOR
(see: I
NPUTS
). The input can be controlled by means of a switch, alarm
control panel, etc. Additionally, the door blocking can be effected by the use of timer or
access schedule not used when programming the user settings. For the timer, it is possible to
program the start / end of blocking in the module. Where an access schedule is used, the
door will be blocked at the time defined by the schedule.
Notes:
•
Switching to the normal operation mode or unblocking the door blocked with the use of
A
LARM
–
BLOCK DOOR
type of input is only possible by means of the procedure that requires
the use of identifier.
•
The timer and the programmed schedule have no priority. This means that occurrence of
other events in the module can change the door status before expiry of the specified
blocking time.
•
Blocking the door by means of the timer, schedule or module input programmed as D
OOR
BLOCKING
is impossible, if the door has been unblocked by means of the F
IRE
–
UNBLOCK
DOOR
type of input.
7.3 Unblocking the door
7.3.1 Unblocking the door with the use of identifiers
The door can be unblocked by the user having the S
WITCHING
right. The user can only
unblock the door when he has access to the door, according to the access schedule.
Note:
If door status control is disabled, door can be unblocked only by means of LCD keypad
and code.
In order to unblock the door by means of the proximity card, do the following:
1. Make sure that the door operates in normal mode, unlock and open the door.
2. Place the card in proximity of the reader and hold it for about 3 seconds – 2 short beeps
will confirm that the door is unblocked.
Note:
If, according to the module settings, the user is to be identified in the LCD keypad /
keypad on the basis of card and code, or code only, then the function of unblocking
the door by means of card will be unavailable in the keypad.
In order to unblock the door by using the code and LCD keypad, do the following:
1. Enter the code and confirm with the
key.
2. Scrolling through the menu by means of the
and
keys, find the U
NBLOCK DOOR
function.
3. Press the
or
key. 2 short beeps will confirm that the door is unblocked.
In order to unblock the door by using the code and ACCO-SCR-BG reader, do the following:
1. Make sure that the door operates in normal mode, unlock and open the door.
