SATA jet 3000 K HVLP, Operating Instructions Manual

Page: 96 / 404

96
EN
Operating Instructions SATAjet 3000 K RP/HVLP
7.1. Adjustment of the Spray Gun Inlet Pressure
Note!
• Pull the trigger fully and adjust the spray gun inlet pressure (see
chapter 2) following instructions of one of the followig sections ( [3-1],
[3-2], [3-3]
to
[3-4]
), then release the trigger.
• With [3-2], [3-3] and [3-4] , the air micrometer [1-8] must be fully
opened/in vertical position.
• If the required spray gun inlet pressure is not reached, the pressure
at the compressed air circuit has to be increased; too high pressure
results in too high trigger forces.
[3-1] SATA adam 2 (accessory / accurate method).
[3-2] Separate gauge with control device (accessory).
[3-3] Separate gauge without control device (accessory).
[3-4] Pressure regulation at the compressed air circuit (most
inaccurate method):
rule of thumb:
pressure at the pressure re-
ducer must be set 0.6 bar higher than the recommended spray gun
inlet pressure per every 10 m of air hose (inner width 9 mm).
7.2. Adjustment of the Material Flow
[4-1], [4-2], [4-3]
und [4-4] - material flow control fully opened
Note!
With the material flow control fully opened, the wear of the fluid tip and
paint needle is reduced to a minimum. Please select the correct nozzle
size depending on the material to be applied and the required applica-
tion speed.
Fully pull trigger and adjust required material supply pressure, e.g. at
pressure tank.
7.3. Adjustment of the Spray Fan Pattern
• Adjust flat fan (factory setting) [5-1] .
• Adjust round fan
[5-2]
.
7.4. Painting
Fully pull trigger for painting
[6-1]
. Operate spray gun according to
[6-2]
.
Maintain spray distance as described in chapter 2.