The Sapling Company, Inc.
1633 Republic Road
Huntingdon Valley, PA 19006
USA
+1 215.322.6063 P.
+1 215.322.8498 F.
www.sapling-inc.com
66
Surface (Wall) Mount Installation (ABS)
1.
Mount Housing to Wall and/or Gang Box -
To mount the housing to the wall, drive two (2) anchors into the wall (not supplied in
kit) and take two pan head screws (also not supplied in kit) and drive them into the inserts leaving an 1/8th inch gap between the head
of the screw and the wall. Mount the housing to the wall by lining up the two holes in the back of the top of the housing with the two
screws with the 1/8 inch gap from the wall and slide the housing onto the heads of the screws. To mount the housing to the gang box,
take the four (4) 6-32 x 1” screws (supplied in kit) and screw them through the four holes in the center of the inside of the housing and
the four holes in the gang box.
Note: If using a metal gang box, a ground must be provided to the gang box.
2.
Feed Wiring Into the Housing -
Take the wire coming from the inside of the gang box and feed it through the hole in the middle of
the housing.
3.
Plug and Secure Wiring -
Loosen the provided wire clamp (comes attached to the inside of the housing) and slip excess wiring
through and tighten the clamp. After securing excess wiring, plug the jack at the end of the wiring into the appropriate jack on the back
of the display board.
4.
Mount Display Board to Housing -
Using the four (4) self tapping, 6-19 x 1/2” flat head screws supplied in the assembly kit, take
the display board and screw it to the front side of the clock housing (4 screws per clock).
5.
Snap on Filter -
Take the red filter bezel and snap it on to the front side of the housing.
6.
Snap on Frame -
Take the gray frame and snap it on to the front side of the housing.
Ins
tal
lat
io
n
