SY265C LC/SY265C LR Excavator OMM
Optional Equipment
SANY
Operation and Maintenance Manual — 0420
7-7
TABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
REMOVE OPTIONAL EQUIPMENT
1. Prepare machine for service. See “Maintenance Safety” on page 2-8.
2. Relieve hydraulic system pressure. See “Relieve Hydraulic System Pressure” on page 5-67.
3. Place a suitably sized container under the hydraulic connection to catch any residual hydraulic oil.
4. Disconnect the optional equipment hydraulic lines according to the manufacturer’s instructions.
5. Install caps and plugs on the hydraulic lines.
6. Disconnect optional equipment from the machine according to the manufacturer’s instructions.
7. Adjust the return flow selector valve as necessary. See “Return Flow Selector Valve” on page 7-5.
8. Select the correct operating mode from the monitor. See “Tool Select Screen” on page 3-49.
9. Check the hydraulic oil level. See “Check the Hydraulic Oil Level” on page 5-29.
WARNING!
• Do not release equipment unless it is on the ground or on a solid, supportive surface. Block
or support equipment to prevent rolling or tipping that could result in death or serious
injury.
• Hydraulic systems operate under high pressure. Escaping hydraulic oil under pressure is
dangerous and could result in death or serious injury. Always relieve pressure before
disconnecting hoses.
Failure to follow these warnings could result in death or serious injury.
NOTICE!
Dispose of hydraulic oil according to all applicable environmental regulations. Failure to
follow this notice could damage the environment.
Summary of Contents for SY265C LC
Page 2: ...Page Intentionally Blank ...
Page 287: ...Page Intentionally Blank ...