-
8
-
3‑2
LCD display
a. Kind of the connecting probe
Display varies depending on the connecting probe and measurement mode as follows.
For Wood
: TG-H, TG-S, MC-3
For Paper
: KG, MC-2
For Mortar
: MORTAR, PLASTER, MC-1
b. Setting of the communication with PC
When the communication function with PC is ON by the key operation, COM is displayed with the
selected communication speed.
This mark is erased in OFF condition.
c. Memory mode
When the memory mode such as storage or retrieve of the data to/from the memory is set,
Mem is displayed with the memory block number. When the no mode is set, this mark is not displayed.
d. Operation of printer
When the printer is in ON condition, Prt is displayed and not displayed in OFF condition.
e. Voltage drop of the instrument proper
When the voltage of the battery supplying the power to the electronic circuit of the instrument proper
drops until less than specific voltage, this mark is displayed.
When this mark is displayed, slide the cover of the battery space at the back side of the instrument
proper downwards and replace all four alkaline dry batteries for the control part of the instrument proper
placed in right hand with new ones quickly.
When replacing the batteries, turn OFF the power switch of the instrument proper before replacing.
If the dropped voltage is raised up to specific voltage with new batteries, the indicated mark disappears.
When the Meter is continuously used after voltage drop mark was indicated on the LCD display,
following conditions will occur.
・
Though it differs depending on the characteristic and using condition of the dry batteries, the Meter
can work for several hours. (Replace all 4 batteries with fresh specified dry batteries earlier.)
・
When the Meter is continuously used as it is, measured values will become unstable.
・
When the power switch is turned ON, the buzzer continuously sounds and key operation become
impossible simultaneously. (Remove the batteries from the Meter.)
・
When no indication is on the LCD display, the batteries are completely consumed.
h.Hold mode
g.Communication speed
i.Upper limit value mark
j.Lower limit value mark
a.Connecting probe
TG‑H
HOLD
H 20.0%
k.Upper limit value
b.Comm. with P.C.
COM：19200bps
L 10.0%
l.Lower limit value
c.Memory mode
Mem：Blk. 150
№
25
m.No. of
d.Operation of printer
Prt
measurement memory
e.Voltage drop of the
instrument proper
f.Voltage drop of printer
E
P
n.No. of memory block
o.Measured value
