SANKI S-CON BABY SBF, Operating And Service Manual

Page: 12 / 32

12
3-2. ELECTRICAL WIRING
Electrical wiring of standard S-CON
®
BABY is provided with START/STOP push button switch and cabtire
cable of 1m (with waterproof connector attached to the end)
coming from m
otor pulley. (→ See figure below.)
NOTE: For 200V three-phase source, machine is occasionally not
provided with START/STOP push button switch, provided with flat type connector only.
Further electrical wiring should be carried out by appropriately qualified specialists.
NOTE: 1. Power cable should be 200V three-phase with an earth or 100V single-phase with an earth.
Machine should be grounded when used.
2. To avoid accidents (overload etc.), be sure to provide safety device(s) such as an earth leakage
breaker (motor breaker) on power source side.
● Standard current of motor pulley (0.4 kW)
NOTE: 1. Use motor breaker applying to rated
current in table above.
2. Keep in mind that current will increase
as well when voltage exceeds rated
voltage.
● Use range of cabtire cable
● Flat type connector
Outlet
Outlet
Plug
Plug
Plug
Earth
Three-point
push button switch
Earth wire (green)
1.25 (0.75) mm
2
×1P
Ring terminal
(attached to main body)
Connector
Ground
Condenser box
Waterproof connector
15A 125V 2P Cabtire cable
1.25mm
2
×2P
Cabtire cable
1.25mm
2
×4P
●
Electrical wiring of standard S-CON
®
BABY
●
100V single-phase
●
200V three-phase
Be sure to ground from
screw (with E label) of
condenser box.
Plug
Connector
Waterproof connector
15A 250V 4P
50Hz
Rated current
Starting current
8.3A
25.5A
3.1A
17.8A
60Hz
Rated current
Starting current
6.4A
24.5A
2.6A
16.2A
Frequency
Current
classification
100V
single-phase
200V
three-phase
100V single-phase 200V three-phase
30m or less
50m or less
100m or less
1.25mm
2
× 2P
2.00mm
2
× 2P
3.50mm
2
× 2P
1.25mm
2
× 4P
2.00mm
2
× 4P
3.50mm
2
× 4P
Cable length
Maximum quantity of
conveyors per outlet 1
(for current capacity of 20A)
3
Cable thickness