10
3-1. FRAME ASSEMBLY
For machine length of 4.5m or less, machine is delivered assembled. (Support stand for transportation is
attached under conveyor middle part. Remove or leave it attached for use.)
For machine length exceeding 4.5m, machine is usually delivered divided into 2 sections. In this case,
assemble machine as follows:
1. To loosen belt, move tail pulley(*4) towards head unit by turning take-up screws(*3).
2. Remove return roller(*5) of tail frame(*2) together with brackets by loosening attachment bolts and nuts
on frame undersurfaces.
NOTE: For trough type S-CON
®
BABY, also remove hopper if attached. If machine has provisional stand
for transportation, also remove it.
3. Unfold belt.
4. Put tail frame(*2) inside belt and put its end on head frame(*1) end so that it will overlap head frame by
approximately 1m. (See figure above.)
5. Spread out belt while moving tail frame(*2) backward. Correctly set belt on top and bottom of frames.
6. Horizontally place head and tail frames(*1, *2). On right and left ends of head frame(*1), make sure that
intermediate joint plates(*6) are correctly fitting to ends of tail frame(*2). Then fix intermediate joint
plates(*6) to tail frame(*2) by tightening bolts and nuts. Make sure that full length of frame is straight
and level on top, not bent in any place.
NOTE: Incorrect frame condition may cause belt deviation.
→ See p.20.
7. Reinstall return roller(*5) in initial position.
NOTE: For trough type S-CON
®
BABY
with hopper, also reinstall hopper. (→ See NOTE on p.11.)
8. Fit belt center to conveyor center. To take up belt, move tail pulley(*4) outward by turning take-up
screws(*3).
NOTE: Turn right and left take-up screws alternately, little by little, so that right and left belt tensions will
be equal. (→ See “５
.
TAKING UP THE BELT”, p.19.) Fo
r electrical wiring and installation of
attachments (stands etc.), see p.12 to 16.
NOTE: When lifting or carrying conveyor, pay special attention not to drop it in order to avoid injury. For
safety, be sure to assemble conveyor by 2 or more workers.
3
ASSEMBLY
Summary of Contents for S-CON BABY SBF
Page 1: ...1 S CON BABY SBF and SBT models BFS and BTS models OPERATING AND SERVICE MANUAL...
Page 30: ...30 MEMO...
Page 31: ...31 MEMO...
