19
5
TAKING UP THE BELT
When belt is slackened off, take up the belt following procedure below:
Move tail pulley(*2) together with take-up brackets(*3) outward by turning right and left take-up
screws(*1) clockwise with a spanner. Belt will then be taken up. When turning take-up screws(*1), adjust
them alternately, little by little, to keep their movement lengths the same.
■
Belt tension
Do not take up belt too much, but only to the extent that belt does not slip on motor pulley
(drive pulley), i.e. enough to drive belt.
NOTE: Excessive belt take-up may overload motor or shorten service lives of belt and
pulleys.
NOTE:
After taking up the belt, if it is not properly aligned, adjust belt alignment. → See “６
. BELT
ALIGNMENT ADJUSTMENT”, p.20
-22.
Summary of Contents for S-CON BABY SBF
Page 1: ...1 S CON BABY SBF and SBT models BFS and BTS models OPERATING AND SERVICE MANUAL...
Page 30: ...30 MEMO...
Page 31: ...31 MEMO...
