21
2. Belt alignment adjustment of conveyor for normal directional use
Adjust belt alignment following procedure below. Start from step A , and finish adjustment when belt is
properly aligned. It may not be necessary to proceed to further steps.
A Adjustment using motor pulley
(→ See fig. 3, fig. 1 and fig. 2.)
On opposite side of cabtire cable, make adjustment depending on direction of belt deviation, as follows. (It
is impossible to make adjustment on cabtire cable side.)
When belt is deviating towards opposite side of cabtire cable: Loosen lock nut of adjustment bolt(*2).
Move motor pulley(*1) shaft end slightly outward by turning adjustment bolt(*2). Motor pulley(*1) will then
be set diagonally and belt will center itself.
When belt is deviating towards cabtire cable side: Loosen lock nut of adjustment bolt(*2). Move motor
pulley(*1) shaft end slightly inward by turning adjustment bolt(*2). Motor pulley(*1) will then be set
diagonally and belt will center itself.
Once adjustment is completed, retighten lock nut of adjustment bolt(*2).
B Adjustment using tail pulley
(→ See fig. 4, and fig. 1 and fig. 2.)
On side to which belt is deviating, move tail pulley(*4) shaft end slightly outward by turning take-up
screw(*3) with a spanner. Tail pulley(*4) will then be set diagonally and belt will center itself.
Alternatively adjust on opposite side. In this case move tail pulley(*4) shaft end slightly inward by turning
take-up screw(*3) with a spanner. Tail pulley(*4) will then be set diagonally and belt will center itself.
C Adjustment using snub pulley
(→ See fig. 3, fig. 1 and fig. 2.)
On opposite side of cabtire cable, make adjustment depending on direction of belt deviation, as follows. (It
is impossible to make adjustment on cabtire cable side.)
When belt is deviating towards opposite side of cabtire cable: Loosen lock nut of adjustment bolt(*6).
Move snub pulley(*5) shaft end slightly inward by turning adjustment bolt(*6). Snub pulley(*5) will then be
set diagonally and belt will center itself.
When belt is deviating towards cabtire cable side: Loosen lock nut of adjustment bolt(*6). Move snub
pulley(*5) shaft end slightly outward by turning adjustment bolt(*6). Snub pulley(*5) will then be set
diagonally and belt will center itself.
Once adjustment is completed, retighten lock nut of adjustment bolt(*6).
Summary of Contents for S-CON BABY SBF
Page 1: ...1 S CON BABY SBF and SBT models BFS and BTS models OPERATING AND SERVICE MANUAL...
Page 30: ...30 MEMO...
Page 31: ...31 MEMO...
