Then press the Select control again.
4. A full reset will be performed, the station list together with any preset stations will be erased and your
wireless network connection details will be lost. All configuration settings will be restored to their defaults,
and the language used for menus will be reset to English.
In the event that you are unable to access the menus (or if the language setting has accidentally been changed
to a language that you cannot understand) the Factory Reset may also be performed as follows:
1. Remove all power from the unit and wait 30 seconds.
2. Then, re-apply power while simultaneously pressing and holding the front panel rotary control. Keep this
pressed as the radio powers up and until it displays 'Factory Reset Complete'. This should normally only take
between 10 and 15 few seconds. Then, release the control while the radio restarts.
3. If this is not successful, please remove power for one minute, and then repeat the operation.
Upgrade firmware
From time to time, new software features for your radio may be developed. For example, a new audio decoder
may be added to allow an alternative audio format to be supported. You radio has therefore been designed to
allow its internal software to be upgraded using your Internet connection. The upgrade mechanism is
accessible via the Configure menu.
Upgrading the software will remove all network settings, radio station presets and alarm settings from your
radio. Do not attempt this procedure unless you have a good Internet connection and a reliable mains power
supply. If you connect to your router using a Wi-Fi connection, make sure that this is also reliable before
proceeding.
The Upgrade Firmware option allows your radio to download new internal software from the Reciva portal on
the Internet. If there is new software available, then the radio will ask whether you want to download it or not.
Selecting No or using the
Back
optionwill cancel the operation. A software upgrade may take several minutes.
IMPORTANT: Do not switch off the power to the radio until the upgrade operation is complete and the radio
has restarted, otherwise the radio may become permanently damaged.
Once the software upgrade is completed your radio will restart. If you use a Wi-Fi connection, you will need
to re-enter all network settings in order to be able reconnect to your network. A firmware update also erases
all radio station presets, alarm settings, and configuration options.
Headphone socket
1. A 3.5mm
Headphone Socket
located on the rear of your radio is provided for use with headphones.
Inserting a plug automatically mutes the internal loudspeaker.
IMPORTANT: Excessive sound pressure from earphones and headphones can cause hearing loss.
