52
If the vessel breaks away from a range of anchor alarm, the alarm sounds and the red circle
blinks in order to advise of the vessel’s break away from the range.
For 'ANCHOR ALARM', move [2.SET]
[1.NAVIGATION SET]
[4.EXITWPT/RTE/ANCHO
R] and press
(
) button or press (
) button.
(
Refer to
☞
‘2.1.4 EXIT WPT/RTE/ANCHOR (Navigation Cancellation)’ )
2.1.4 EXIT WPT/RTE/ANCHOR
(Navigation Cancellation)
This function enables the operators to clear the Waypoint Navigation, the navigational functions of
Route Navigation, Anchorage Setup and Monitoring Setup.
Press
(
) button, then the above-shown navigational functions, the anchorage setup,
the monitoring setup will be all cleared.
(
)
[2.SET]
(
)
[1.NAVIGATION SET]
(
)
[4.EXIT WPT/RTE/ANCHOR]
(
)
[ Ref. ]
☞
☞
☞
☞
If the anchor alarm is set [OFF], the red circle and alarm sounds don’t take place
in a plotter screen.
[ Ref. ]
☞
☞
☞
☞
As for clearing the setups of Navigation, Anchorage and Monitoring, use (
)
buttons with convenience.
Summary of Contents for Navis 3800
Page 6: ...7 This chapter provides an overview of the GLOBAL POSITIONING SYSTEM GPS 1 1 1 1 GPS PLOTTER...
Page 16: ...17 3 Power ON OFF Power ON Press Power OFF Press and hold approximately 2 sec...
Page 19: ...20 GPS Plotter Display C MAP Plotter Display 31...
Page 23: ...24 Fish finder Combo Display Fish finder Display...
