Incite Fire HFC-SBR-23-03, Manual

Page: 1 / 11

OVERVIEW
This device is an assembly of an HFW - SIM - 01 - AS Hyfire system interface module and a HFC - WSR - 03 conventional sounder / HFC - SBR - 23 -
03 conventional s visual alarm device. Sounder’s output is activated following an alarm condition of the Hyfire system.
INSTALLATION - IMPORTANT NOTES
- The device must be installed following your national and/or international codes of practice and standards: check them before performing the
installation of this device.
- Test this device after installation.
HFW - SIM - 01 - AS + HFC - WSR - 03
HFW - SIM - 01 - AS + HFC - SBR - 23 - 03
HYFIRE TYPE B WALL SOUNDER
HYFIRE TYPE B WALL S VISUAL ALARM DEVICE
INSTALLATION
1) Detach the front operating section from the sounder back box (→ SOUNDER OPENING PROCEDURE ).
2) Extract the HFW - SIM - 01 - AS from the sounder’s back box (→ MODULE’S EXTRACTION ).
3) Set the HFW - SIM - 01 - AS ’s link switch to ON.
4) Extract the HFW - SIM - 01 - AS ’s battery covers.
5) Insert both batteries into their HFW - SIM - 01 - AS holders, oriented as per polarity marks.
6) Link the HFW - SIM - 01 - AS device to the Hyfire system (→ LINKING ).
7) Reinstall the battery covers.
8) Check the wireless link quality of the HFW - SIM - 01 - AS positioned in the final installation location (→ WIRELESS LINK QUALITY
CHECK ).
9) Install the sealing pad if the sounder is to be installed outdoors and/or in damp environments ( not EN 54 - 3 approved )
(→ OUTDOORS AND DAMP ENVIRONMENTS INSTALLATION ).
10) Fix the sounder back box to the wall on the final installation location (→ WALL INSTALLATION ).
11) Reinstall the HFW - SIM - 01 - AS into the sounder’s back box (→ MODULE’S INSTALLATION ).
12) Set sounder’s tone and volume (→ OUTPUT TONE SETTING , → OUTPUT VOLUME SETTING ).
13) Reinstall the front operating section onto the sounder back box (→ SOUNDER CLOSING PROCEDURE ).
14) Test the HFW - SIM - 01 - AS + HFC - WSR - 03 / HFC - SBR - 23 - 03 to check if it works properly (→ TESTING ).