Samsung SC-D263, Service Manual

Page: 137 / 244

Operating Instructions
11-15
Samsung Electronics
ENGLISH
37 37
Basic Recording
Searching a quickly for a desired scene (Setting the ZERO MEMORY) (SC-D364/ D366 only)
The ZERO MEMORY function works in both <Camera> and <Player> modes. page 19
You can mark a point on a tape that you want to return to following playback.
1. Set the [Power] switch to [CAMERA] or [PLAYER].
2. Set the [Mode] switch to [TAPE].
3. Press the [ZERO MEMORY] button on the remote control before the recording or during
playback at the point where you wish to return.
The time code is changed to a tape counter that is set to ZERO MEMORY with the
<
0:00:00> (ZERO MEMORY indicator).
If you want to cancel the ZERO MEMORY function, press the [ZERO MEMORY] button
again.
4. Finding the zero position.
When you have finished playback, fast forward or rewind the tape in stop mode.
The tape stops automatically when it reaches the zero position.
When you have finished recording, set the [Power] switch to [PLAYER] and press
the [
ÏÏ
(REW)] button.
The tape stops automatically when it reaches the zero position.
5. The tape counter with the < > (ZERO MEMORY indicator) disappears from the display and the tape counter is
changed to the time code.
[ Notes ]
In the following situations, ZERO MEMORY mode may be canceled automatically:
- At the end of the section marked with the ZERO MEMORY function.
- When the tape is ejected.
- When you remove the Battery Pack or power supply.
The ZERO MEMORY may not function correctly where there is a break between recordings on the tape.
Ï
CA M
ER
A
PLAY
ER
1
ENGLISH
38 38
Basic Recording
Self Record using the Remote Control (Setting the Self Timer) (SC-D364/ D366 only)
The SELF TIMER function works only in <Camera> mode. page 19
When you use the SELF TIMER function on the remote control, the recording begins automatically in 10 seconds.
1. Set the [Power] switch to [CAMERA].
2. Set the [Mode] switch to [TAPE].
3. Press the [SELF TIMER] button until the appropriate indicator is displayed.
4. Press the [Start/Stop] button to start the timer.
SELF TIMER starts counting down from 10 with a beep sound.
In the last one second of the countdown the beep sound gets faster, then recording
starts automatically.
If you want to cancel the SELF TIMER function before recording, press the
[SELF TIMER] button.
5. Press the [Start/Stop] button again when you wish to stop recording.
[ Notes ]
Do not obstruct the remote control sensor by putting obstacles between the remote
control and Camcorder.
The remote control range is 4 ~5m (13 ~17 ft).
The effective remote control angle is up to 30 degrees left /right from the center line.
Using a tripod is recommended for delayed recording.
Ï
CA M
ER
A
PLAY
ER
1
3
PLAYE
R
CA
M
ER
A
QUIC
K
MENU
4
Ï