CHAPTER 3. Installation
OfficeServ 500 Wireless LAN Service Manual/Ed.00
Page 3-12
© SAMSUNG Electronics Co., Ltd.
6
Registering/Clearing the WIP-5000M Terminal
The WIP500M terminal must be registered to the system to be used in the OfficeServ
500
System Wireless LAN. This section introduces the procedures for registering and
clearing the register of a terminal.
6.1
Registering a WIP-5000M
Register a WIP-5000M terminal following the instructions below.
1) Confirm if the system DB items are set according to the ‘Setting the System DB’
section of this chapter.
2) Register the WIP-5000M terminal at the register menu.
Refer to the ‘WIP-5000M User Manual’ for the register procedure.
3) The Network ID shall be entered correctly during the WIP-5000M register
procedure. Especially, the User ID and Password shall be identical to that of the
system. If an error occurs during execution of register procedure, check the
system DB settings and repeat the procedure above.
4) An extension number will be assigned to the WIP-5000M upon completion of
the terminal register.
6.2 Clearing a WIP-5000M
Where theft or breakage of a WIP500M Station causes a new terminal to be
registered, registration of the previous terminal shall be deleted.
The clearing procedure for the WIP-5000M is described below.
Clearing from the System
To clear the WIP500M in use, which is within the wireless LAN service area, set the
normal mode through the system MMC.
If the terminal is not within the service area or is not in use, delete the terminal’s
registration DB in the system using the forced mode through the MMC system.
Clearing from the WIP-5000M
The terminal’s registration DB may be deleted from the WIP500M within the
wireless LAN service area. Refer to the ‘WIP500M User Manual’ for termination
procedure in detail.
