22 _ Disassembly and Reassembly
Part
Figure
Description
Motor AC drive
Preparation:
• Disasssemble the Assy rail.
- Refer to the “Assy rail” disassembly section to
separate Assy rail.
1. Remove one (1) screw.
2. Remove Motor AC drive
Switch micro
Preparation:
• Disassemble the Motor AC drive.
- Refer to the “Motor AC drive” disassembly section
to separate Motor AC drive.
1. Pull out the micro switch by lifting up the hook in red
square.
Bracket lower -
right
①
②
Preparation:
• Disassemble the Assy motor holder.
- Refer to the “Assy motor holder ” disassembly
section to separate Assy motor holder until step 2.
1. Turn The Bracket lower right in the direction of
Yellow arrow
②
in state that the Hook is not hanged
in Cover nozzle by pushing the hook in the direction
of the Red arrow
①
.
Assy Cover
nozzle
Preparation:
• Disassemble the assy guide water/ assy holder
motor / bracket lower-right.
- Refer to the “Assy guide water”, “Assy holder
motor”, “bracket lower-right” disassembly sections
to separate Assy guide water/ assy holder motor /
bracket lower-right.
- Disassemble the Cover nozzle by pushing it down.
Caution
- Be careful not to lose the gear.
• There are two gears in total.
Gear Upper : Small, attached with Housing.
Gear Lower : Big, inside the cover nozzle.
- Be careful not to break the Hook on rear.
- Do not break the hole parts of Tub.
