Samsung DW80K5050US, Service Manual

Page: 44 / 65

42 _ Troubleshooting
Item
Related
Parts
Symptoms Description
Manual Mode
Configuration
6. [Manual Mode STEP 6: drain]
1) Operate the drain pump.
2) Follow the same steps as PreDrain.
3) If water level is not detected after draining, the drain inspection code is activated.
4) For models without low water level detection, proceed to the next step after draining without the drain inspection code.
7. [Manual Mode STEP 7: operate Auto Door Open Actuator]
1) Operate Auto Door Open Actuator. (Only for models with the relevant part)
- If the Door does not open within 3 minutes after the Auto Door Open Actuator is run, it will Retry once(10 seconds Off, 3 minutes On).
- If the Door does not open after the retry, a DC3 check code will occur.Before the DC3 check code occurs, operate the Auto Door
Open Actuator for an additional 30 seconds during Door open detection.
8. [Manual mode step 8: Water Tank water filling operation]
Please refer to the diagram below for the control times of the control components that run in this mode.
(Applicable only to models that have the relevant running parts.)
For the Water Tank water filling operation in the diagram, please refer to the water filling operation of
[Dishwasher - Additional function – Water Tank control function]. (Operates regardless of the Water Tank State.)
9. [Manual mode step 9: Water Tank water draining operation]
The Tank Actuator Main, Sub Valve operates in this mode (in models that have the relevant running parts), and the control time
is the same as that of the Tank Actuator Main, Sub Valve in water supply action using water in the Water Tank of [Dishwasher -
Additional function – Water Tank control function]. Complete the Tank Actuator Main, Sub Valve action and then wait 30 seconds to
complete the operation. (Operates regardless of the Water Tank State.) Change the Tank Actuator status to Some Fill right before
the Tank Actuator Valve turns On and then save to EEPROM. After completing the Tank Actuator Valve operation, change the Tank
Actuator status to Empty and then save to EEPROM.