Disassembly and Reassembly _ 31
Part
Figure
Description
Heater
Preparation:
•
Make sure to disconnect the power.
•
Disassemble the cover sump & cutter disposer.
•
Disassemble the shutter & bracket front lower.
- Refer the each disassembly section.
1.
Remove the two (2) heater connectors.
2.
Remove a ground screw on the heater bracket.
3.
Loosen the nut between the heater terminals.
(10mm).
4. Remove the heater by pulling it out of the sump
assembly.
Caution
The heater may be very hot. Make sure to check it
before touching the heater.
Caution
Make sure to check if there is any water in the
sump assembly. Remove any remaining water, to
prevent water leakages while servicing.
