English -
21
After all connections are complete, plug the power cord
in the wall outlet.
“AUTO” in the front panel display flickers.
This means that the current time is being set
automatically (Auto Program) through the
antenna under connection and also the channel is
being set. The setup may take a few minutes.
When it normally operates, the current time is automati-
cally set and displayed in the front panel display.
If “- - - -“ appears, however, it means that auto
time setting has failed.
In that case, set the current time through the
manual initial setup, as shown in step 8.
Install Batteries in the Remote Control
●
Open the battery cover on the back of the remote.
●
Insert two AAA batteries. Make sure that the polarities
(+ and -) are aligned correctly.
●
Replace the battery cover.
If remote does not operate properly:
●
Check the po - of the batteries (Dry-Cell)
●
Check if the batteries are drained.
●
Check if remote sensor is blocked by obstacles.
●
Check if there is any fluorescent lighting nearby.
Dispose of batteries according to local environmental
regulations. Do not put them in the household trash.
Setting the Remote Control
You can control part of another manufacturer’s TV
functions with this remote control.
Control function buttons involve: TV POWER, Channel
Up/Down, Volume Up/Down, Direct Number buttons,
TV MUTE, INPUT, ENTER and ARROW button.
Step 6 : Connecting the Power
Cord
Step 7 : Preparing the Remote
Control
■
After “AUTO” message disappears, the
recorder will perform Auto Channel
Memory for about 3 minutes. If power is
on, while Auto Channel Memory is in
process, Auto Channel Memory will be
stop.
In this case, do Auto Channel Memory
from MENU(see page 26).
NOTE
C
onnecting & Setting UP
