SAMES KREMLIN PRIMA 01D100, User Manual

Page: 49 / 108

Diagnostic help / Troubleshooting guide
582195110-Complete_Pump-PRIMA-01D100-EN-indA 49
Defaults Possible causes Remedies
Pump running slowly,
irregularly or stalling; poor
flow
Presence of ice Remove the muffler cover. Clean
and/or remove ice. Reassemble the
muffler.
Install an air dryer.
Collectors clogged Clean the collectors to allow good
circulation of the product.
Network pressure greater
than or equal to the air inlet
pressure
Increase the pump air inlet pressure.
Bubbles on the suction side Check the suction and tightness
conditions between the pump and
the suction rod (or cup). Bring the
pump closer to the product.
Lack of air Check the size and length of the air
line and the capacity of the
compressor.
Check for grease in the air ducts
Clean them if necessary.
Excessive suction height If liquid is sucked in from a height of
more than 6 m / 236”, the pump will
prime if the chambers are filled with
liquid.
Air inlet pressure and / or
volume too high
Decrease the pressure and / or the
volume.
Inappropriate suction line Use a pipe size equal to or larger
than the pump connection.
Change the suction rod if necessary.
Restrictive or inappropriate
air supply
Use an air hose that fits the inlet
connection. The total length of the
hose should not exceed 1.5 m
/ 4.9 ft.
Check the condition of the air hose.
Change it if necessary.
Air leakage on the suction
side or presence of air in the
product
Inspect all tightness seals and fittings
- suction side. Replace them if
necessary.
Suction line clogged Remove or empty any items causing
the blockage.
Check and empty all suction screens
and strainers.