![background image](http://html1.mh-extra.com/html/sames-kremlin/nanogun-airmix-h2o/nanogun-airmix-h2o_user-manual_3696968037.webp)
Index revision : A
37
7118
Level 3: If the magnet is broken or lost.
•
Replace the complete air valve (Ref.: 910015405) (
see § 10.10 page 35
).
Before using the gun, inspect the high-voltage on and off switches.
If the high-voltage is permanently activated, disassemble the handle and remove one of the
washers that serve to adjust the reed sensor position; proceed step by step without removing
multiple washers at a time.
If the high-voltage does not activate, don’t disassemble the handle and instead add a washer
to adjust the reed sensor position; proceed step-by-step without adding multiple washers at the
same time.
WARNING : Various washer thicknesses may be installed, always begin by adding or removing
the thinnest.
10.10.1.1. Magnet assembly direction
•
Case no. 1:
For guns of type 1 (see serial no.). Back stop without a marking, the sliver-
plated side of the magnet must make contact with the shoulder of the back stop.
•
Case No. 2:
For guns of type 2 (see serial no.). Back stop with markings, the black side of
the magnet must make contact with the shoulder of the back stop.
10.11. Fastening hook
• Place the switch in the “I” position. Using a 5.5-
mm screwdriver, unscrew the washer head
screw and remove the hook by pulling
upward.