Index revision : A
44
7118
Reassembly
:
•
Step 5
:
Remove the placebo injector.
•
Step 6
:
Coat the rear part (threading / seal)
of the dielectric grease injector.
•
Step 7
:
Add more and/or put back the die-
lectric grease on the HV contact. Coat the
external thread of the barrel with dielectric
grease.
•
Step
8
: Put the internal cone and the cap back in place. Tighten the cap nut.
11.4. Elimination of wastes
The removal, transport and elimination of wastes generated by use of the equipment (used sol-
vent, unused paint, residue, dirty cloths, booth sludge, water from curtains applied in the booth,
used dry filters, ventilation air, etc.) must take place in strict compliance with current local reg-
ulations.
