SAMES KREMLIN
Page 20
Manual : 573.226.112
DECOMMISSIONING
-
Switch off the device 10 min. before the
end of work.
-
Turn the thermostat to position "I-OFF"
(Refer to figure below).
-
Use the residual heat until the end of
work. The cooling time also shortens until
the flushing.
- Flush the device.
- Prevent damage to the device and the entire system by thoroughly flushing the device
after each decommissioning.
- Observe and follow the information in the operation manual for the spraying device and in
§ 6 - Flushing.
STORAGE
Store the equipment in a place where it is protected against dirt, moisture, frost, and heat.
DISPOSAL
It is necessary to collect residues of spraying material, cleaning fluids, oil, greases and other
chemical substances according to the legal regulations for recycling or disposal. The official local
waste water protection laws apply.
At the end of the equipment's use it must be put out of use, disassembled and disposed of
according to the legal regulations.
Thoroughly clean the equipment of material residues.
Disassemble the equipment and separate the materials - metals must be taken to a scrap
metal depot, plastic parts can be disposed of with household waste.
7. TESTING AND MAINTENANCE
If untrained personnel carry out maintenance and repair work, they
endanger themselves and others, as well as risking the operational safety
of the equipment. Maintenance and repair work on electrical parts must
be carried out by specialist personnel with an electrical qualification - all
other maintenance and repair work must be carried out by Sames
customer service or specially trained personnel.
Prior to maintenance and repair work:
- Shut off the compressed air supply for the entire spraying system.
- Disconnect the power supply.
- Depressurize the entire spraying system.
NOTA
: Observe and follow the operation manual for the spraying device and accessories used for
this.
The device must be regularly checked by expert personnel according to DIN EN 60079-17 when
using it in potentially explosive areas.
