SAMES KREMLIN
Page 5
Manual : 573.226.112
TOXIC PRODUCT HAZARDS
Toxic products or vapours can cause severe injury not only though contact with the body, but
also if the products are ingested or inhaled. It is imperative :
•
to know the material products and their risks,
•
notified or hazardous materials must be stored in accordance with the regulations,
•
the material must be stored in an appropriate container, never place materials in a
container where there is a risk of spillage or leakage,
•
a procedure must be applied for the safe disposal of waste material. It must comply with
all prevailing regulations and legislations of the country where the equipment is to be used,
•
protective clothing should always be worn in compliance with the material manufacturers'
recommendations,
•
depending on the application and chemical safety instructions, safety glasses, hearing
protective earplug, gloves, foot wear, protective masks and possible breathing equipment
should be worn to comply with the regulations (Refer to chapter "Safety equipment” of
Sames
selection guide).
CAUTION!
It is forbidden to use material containing high concentrations of halogenated hydrocarbon
solvents with
aluminium
or
zinc fillers
. Non-compliance with the instructions may cause
explosion risk causing serious or fatal injury.
EQUIPMENT REQUIREMENTS
Guards (motor cover, coupling shields, connectors,…) have been designed for
a safe use of the equipment.
The manufacturer will not be held responsible for bodily injury or failure
and / or property damage due to destruction, the overshadowing or the
partial or total removal of the guards.
PUMP
Before carrying out any work, it is imperative to read and clearly understand the disassembly and
reassembly instructions before servicing. The operator must understand the equipment and the
safety instructions. These instructions are available in the equipment manuals.
The air motor is designed to be mounted with a pump. Never modify any components or
couplings. When operating, please keep hands away from moving parts. Before starting up the
equipment, please read the PRESSURE RELIEF instructions. Please ensure that any relief or
drain valves fitted are in good working order.
HOSES
•
Keep hoses out of circulation areas, moving parts or hot surfaces,
•
Never expose product hoses to temperature higher than + 60°C / 140° F or lower than
0°C / 32° F,
•
Never pull or use the hoses to move the equipment,
•
Tighten all fittings as well as the hoses before operating the equipment,
•
Check the hoses regularly; change them if they are damaged,
•
Never exceed the maximum working pressure (MWP) indicated on the hose.
