Tel: 886. 909 602 109 Email: [email protected]
www.salukitec.com
76
Frequency Sweep Configuration:
Choose the button
to configure internal frequency sweep as is shown in Fig 61. The details of
configuration are shown in Table 5.
Fig.61 The Configuration Area of Internal Frequency Sweep
Table 5. Internal Sweep frequency Reference Configuration
Int. Sweep Type
Linear
Log
Int. Sweep Start
(Hz)
Setting the start frequency of sweep manually. The frequency range is
from 1mHz to 3MHz and the minimum resolution is 1mHz.
Int. Sweep Stop
(Hz)
Setting the stop frequency of sweep manually. The frequency range is
from 1mHz to 3MHz and the minimum resolution is 1Hz.
Linear Step Time
(ms)
Setting the step time for every sweep manually. The step range is from
1ms to 100s and the minimum resolution is 1ms.
Int. Sweep Step
(Hz)
Setting the step frequency for every sweep manually. the step range is
from 1Hz to 3MHz and the minimum resolution is 1Hz.
Int. Sweep Run
Mode
Single
Loop
Stop
Note that:
After finishing all the settings, click the button
to finish the configuration for input signal.All
settings can be changed at the same time and you just need to click this button once.
