Tel: 886. 909 602 109 Email: [email protected]
www.salukitec.com
57
If press the [PAUSE] button when the sampling is executing. Sampling will be paused. In this case, press the
[START/CONT] button and the sampling will be continued.
3.11.2 < PAUSE/CLEAR >: Pause Sampling or Clear Sampling Data
The [PAUSE/CLEAR] button has two functions. One is to pause sampling. Another is to clear the sampling data.
Press this button to pause data sampling when the sampling is executing. The <Chart> will also pause at the same time.
Then if press this button one more time, sampling will be stopped and data will be cleared. Besides, the chart will also be
cleared when in the <Chart> status.
3.11.3 < CURSOR >: Display and Hide of Cursor in <Chart> Map
The [CURSOR] button has two functions. One is to display or hide the <Cursor> in <Chart> status. Another is to choose
<Cursor> again in other status.
When there is no cursor in <Chart>, this button can call out <Cursor>. Move <Cursor> through spinning the knob and
then read the measurement value. If the <Cursor> has been paged out but not chosen (for example, when <Sensitivity> is
highlighted and then the knob is only used to set parameters on <Sensitivity>), the <CURSOR> button can pick on
<Cursor> again. Press the [CURSOR] again when the <Cursor> is already picked on, in this case, the <Cursor> will be
hidden.
Spin the knob to move <Cursor>. If the <Cursor> exceeds the edge of <Chart>, the <Chart> will change to the next page.
Also, <Cursor> can be positioned directly through <Curve Point> in <Disp More> menu. [CURSOR] makes sense when
the data sampling is executing or pausing.
3.11.4 < ACTIVE CHART >: Choose <Chart> as the Active Area
The [ACTIVE CHART] is used to choose the <Top> or <Bottom> area of <Chart> as the current active area. <Cursor>
only makes sense in active area. The chosen active area will be highlighted at the top-left corner of the <Chart>. The
<Chart> in <Full> area is always active. Therefore, the [ACTIVE CHART] button makes no sense to <Full> area.
