64
Tel: 886.909 602 109 Email: [email protected]
properly. You may also check current status via [Self-test]. Please contact us if self-test does not pass. Contact information is provided in
1.3. Operating steps of running self-test are as below:
1) Press
【
System/Local
】
key and enter system menu bar;
2) Click [Next] menu and enter the second page of system menu bar;
3) Click [Self-test] menu to call up a selection dialog box of “Self-test”; in this dialog box, you may check self-test results of each item
such as EEPROM, FPGA, CPLD, internal temperature and power supplying condition etc. As shown in Figure 6-17:
Figure 9-17 Self-test of Instrument
9.9.
Frequency Reference (10MHz)
S3101 Cable & Antenna Analyzer provides input/output interface for 10MHz reference clock. You may use Analyzer to provide 10MHz
reference clock for other Analyzers. You may also use external 10MHz clock for this instrument. Operating steps of 10MHz reference
clock input/output function are as below:
1) Press
【
System/Local
】
key and enter system menu bar;
2) Click [Next] menu and enter the second page of system menu;
3) Click [Freq Ref Int Ext] menu on system menu; Analyzer utilizes self-produced 10MHz clock reference when displayed as [Freq Ref
Int Ext]; you may need to connect external 10MHz clock reference through port to make Analyzer run properly.
