21
Tel: 886.909 602 109 Email: [email protected]
Figure 3-17 Battery Installation or Replacement Procedures
3.4.2.
Viewing Battery Status
The user can view the battery status in either of the following methods:
1) Check the battery icon in the system status bar, which indicates the approximate level of charge. If only 1 bar left, please timely
replace or charge the battery.
2) Press
【
System/Local
】
to enter system menu, click [Next Page]→[Self-test] to check the current battery remaining power in the
power supply item.
3) Remove the battery, and press the key with a white point on the battery end, the indicator on the battery will light to indicate the
current remaining battery power. If only 1 bar left, please timely charge the battery.
3.4.3.
Charging a Battery
User can recharge the battery in the S3101 Cable & Antenna Analyzer while the analyzer is operating or when it is turned off. The
charging procedures are as follows:
1) Install the battery in the Analyzer.
2) Plug in the supplied AC-DC adapter and switch external power on.
3) The yellow LED on the left bottom corner of the front panel lights and flashes when charging with power off, indicating that the
battery is charging, and the constant yellow LED indicates complete charge; the green LED lights and flashes when charging with
power on, indicating that the battery is charging, and the constant green LED indicates complete charge. At that time, the battery
icon on the right of touch screen system status bar will show the battery is fully charged.
Moreover, the charging time for a fully depleted battery is approximately 4h.
Pull down
battery cover
Open battery
cover
Install / pull out the
battery
Close battery
cover
Push up battery
cover
