Sakai SV410-2, Operator'S Manual

Page: 25 / 77

– 20 –
Monitor display
★
Indicator lamps [ ]
Light up when corresponding systems have been are operating.
★
Warning lamps [ ]
Go on when the starter switch is turned to the ON position and go off when the engine has
started. If any light up while the engine is running, this indicates a faulty condition. Stop the
engine and trace the source of trouble.
★
Checking for warning lamps and parking brake indicator lamp
They should turn on light when the starter switch is ON position. If not, there is some trouble.
Check and repair the combination meter or wiring harnesses.
CAUTION
Hydraulic oil filter warning lamp may go on when the engine rpm is increased before
the engine has been warmed up enough. Keep the engine idling until the lamp goes
off, before starting your work.
Engine warning Lamp
★
Engine warning
When the engine stop lamp lights up, serious trouble has
occurred in the engine. Stop the engine. Ask for appropriate
inspection, maintenance, or repair.
Vibrator indicator lamp
Goes on when vibrator is operating.
Engine oil pressure warning lamp
Goes on when engine lubricating oil
pressure is lowered below specified value.
Battery charge lamp
Goes on when trouble have
occurred in electric system
while engine is running.
Parking brake indicater lamp
Goes on when parking brake is engaged.
Hydraulic oil filter warning lamp
Goes on when filter is clogged.
– 21 –
2.1.3 Switches
Starter switch
Starts and stops the engine.
OFF:
The key can be removed in this position. All the
electric systems are switched off. To shut down
the engine, move the key to this position.
ON: The charging circuit and lamp circuit are charged
with electricity. Leave the key in this position after
the engine has started.
START: The engine is cranked and gets started. The
moment the engine has started, release the key.
It will automatically return to the ON position.
CAUTION
Set the Forward - Neutral - Reverse (F-N-R) lever in the neutral position and press
down the parking brake seitch before starting the engine. Unless these conditions
are met, the engine will not start.
Parking brake switch
If switch is pressed down, the parking brake will be
applied with the indicator lamp on the dashboard lit
up.
When pressed again, the brake is released and the
indicator lamp goes off.
WARNING
• To disengage the brake, be sure to press the button again instead of pulling it.
• Always press the button to apply the parking brake before dismounting from the
machine.
CAUTION
Never pull the switch up.
IMPORTANT
In an emergency, apply brake by pressing the parking brake switch button.
OFF ON ST
AR
T
Applied
Released