– 22 –
Horn switch button
Pressing the button at the center of the steering wheel
sounds the horn.
Vibration switch
By means of vibration switch located on the panel,
selection of vibration amplitude and On-Off is mode.
position: Turning the vibration switch clockwise causes
the vibration to start with high amplitude.
position: Vibration is shut down.
position: Turning the vibration switch counter clockwise
causes vibration to start with low amplitude.
NOTE: For vibratory rolling, run on full throttle.
Vibration selector switch
Selection can be mode between the vibration switch
installed to the Forward-Neutral-Reverse (F-N-R) lever
and the other one located on the panel.
position: Vibration can be turned ON or OFF with
the switch located on the Forward-Neutral-
Reverse (F-N-R) lever. Pressing this switch
causes the vibration to start and pressing it
again to stop.
This vibration switch on the lever should be
used with the vibration switch on the panel
placed at or position.
CONT position: Have this switch placed at this position when
vibration is not to be actuated.
NOTE: For vibratory rolling, run on full throttle.
Vibration selector switch
CONT.
Vibration switch
Vibration switch
Summary of Contents for SV410-2
Page 4: ......
