Sailor UAIS1900, Technical Manual

Page: 49 / 108

UAIS DEBEG 3400, Electronics Unit
ED3047G142 / 08 (2004-06)
Technical Manual
5 Setting-to-Work/Configuration
5.1 Setting-to-Work
t_ue_e05.fm / 21.06.04
49
5 Setting-to-Work/Configuration
5.1 Setting-to-Work
1. The AIS Electronics Unit and the antennas must be installed as described in Section 3 (I n s t a l l a t i o n
R e c o m m e n d a t i o n s ). For information about the dimensions see Section 10 (O u t l i n e D r a w i n g s ).
2. The cabling and connection must be performed corresponding to the Cabling Documents in Section
9.
3. Depending on the system in which the AIS has to be integrated, the configuration has to be
performed as described in Section 5.3.
5.2 Software Versions
The software versions can be downloaded as packages with the software components for all units of the
AIS system. For further information about the download and the update see Section 6.3 on page 57.
5.3 Configuration
No adjustments have to be performed on the antennas. These components are ready for use.
The AIS Electronics Unit must be parameterized via a connected RADARPILOT 1000, CHARTPILOT
9320/30, MULTIPILOT 1000 or the Display and Control Unit DEBEG 3401.
For information in detail, see the corresponding Technical Manuals and the On-line Help of these
systems.
The following descriptions are an aid for the configuration of the AIS.
NOTE:
Valid for NACOS xx-3 Systems only:
The AIS Electronics Unit is connected to the Ship’s Interface. The output interfaces of the
Ship’s Interface must be configured as follows:
- Select "IEC 61162-1 edition 2/2000 (NMEA 2.3)" as driver
- Set a repetition interval of 1 s for the following telegrams:
-
GLL
- VTG
- HDT
- ROT
- VBW (if bottom-track log is available)
NOTE:
The system from which the AIS Electronics Unit has been configured and the AIS itself must be restarted
after any change in the configuration. Otherwise these modifications may have no effect.