![background image](http://html2.mh-extra.com/html/icom/ic-v80/ic-v80_step-by-step-programming-manual_3765650001.webp)
Icom IC-V85 Step-by-Step Programming Guide
Also applies to IC-V80
Noji Ratzlaff
Set the radio to communicate with a repeater at 146.780- MHz, 100.0 Hz
0.
Turn on the radio and make sure it’s unlocked
1.
CLR (VFO mode)
2.
Set the frequency
1 - 4 - 6 - 7 - 8 - 0
3.
If the – sign appears at the top, skip to step 6
4.
Set the repeater offset
FUNC - 8 -
(± 0.60) - CLR
5.
Set the repeater shift direction
FUNC - 4 (–)
6.
Set the transm it tone frequency
FUNC - 8
(rt) - rotate volume (100.0) - CLR
FUNC - 1 (
*
)
7.
Set the transm it pow er level
FUNC - 9 (H) - CLR
Your radio is now set to transm it as specified
Store and name the current repeater and tone settings in a memory channel
0.
Follow the procedure above to set your radio
for the frequency of your choice
1.
Store the frequency in channel 37
FUNC - M R -
(37) - FUNC - M R (hold)
The frequency is now stored in radio mem ory
2.
M R (channel mode)
3.
Set NAM E m ode
FUNC - 8
(If this doesn’t put you in nam e edit mode,
turn off the radio, then
and
and PW R
sim ultaneously, then select dSP.Nm )
4.
Rotate the knob and then
to edit the nam e,
then CLR
The stored m em ory channel now has a nam e
Recall a stored memory setting
0.
Turn on the radio and make sure it’s unlocked
1.
M R (channel mode)
2.
Select the tw o-digit channel num ber
3 - 7
The stored channel is now ready for use