Sailor 100, Installation Manual

Page: 90 / 186

Configuration with the web interface
6-18 Chapter 6: Configuration 98-136280-B
6.3.5 Reference satellites
Reference satellites are used during Azimuth adjustment function (see Azimuth
adjustment on page 6-20). They may also be used for Azimuth calibration.
When to update the data of a reference satellite
The data of a reference satellite should not be edited and new data should not be
added. The Reference satellites and their transponder data have been carefully
selected. They have some rare attributes and properties that makes them uniquely
identifiable throughout the globe.
Removing and disabling entries
You can only delete user defined entries. Pre-installed entries can be disabled if they
are not needed.
Important
Do not add satellites that are solely intended for azimuth calibration. If
you cannot use any of the pre-installed Reference satellites for azimuth
calibration, you can manually supply the data directly on the page
SERVICE > Calibration , see Heading and calibration of azimuth on page 6-
4.
Important
For the Azimuth adjustment function to work properly, it is essential that
these data are not edited or new data are added unless instructed to do
so by your service partner.
Figure 6-12: Reference satellite, remove and disable
Note
Only user defined entries have the delete link.
SAILOR100IM.book Page 18 Friday, January 18, 2013 10:28 AM