28
2. Modify Alarm Mode and Arm/Disarm in SET Mode
Enter # # # A A A A A A # to enter into set-up mode and modify alarm mode.
①
Arm the host in phone alarm mode
Enter 1 # to arm in phone alarm mode and exit set-up mode.
②
Arm in on-site alarm mode
Enter 3 # to arm in on-site alarm mode and exit set-up mode.
“A A A A A A ” refers to a 6-digit set-up password. The factory default set-up
password is “112233”. Once arm is completed, the host will automatically exit
set-up mode and is under leaving state. If leaving time is not set up, the host will
enter into arm mode immediately, and the indicator for the corresponding defense
zone and “ARM” indicator will light up.
③
Disarm
Enter 2 #, and then the host will automatically disarm.
This disarm operation does not cause detector alarm information and failure
information to be deleted.
Once the above mentioned arm/disarm operation is completed, the system will
automatically exit set-up mode.
3: Arm/Disarm by Remote Control
Press the “Full Arm” key on the remote control, and then your alarm host will
indicate through voice prompts that you are entering into full arm mode.
Press the “Partial Arm” key on the remote control, and then your alarm host
will indicate through voice prompts that you are entering into partial arm mode.
Press the “Disarm” key on the remote control, and then your alarm host will
indicate through voice prompts that the host is being disarmed.
4: Remote arm/disarm by fixed phone or mobile phone
Please refer to relevant operation procedures in “Alarm Receiving Operation”
and “Remote Set-up”.
2.
2.
2.
2.
Alarm
Alarm
Alarm
Alarm Operation
Operation
Operation
Operation
Anti-theft Operation:
Before you leave your residence or work place, please follow any of
