23
For the first two steps, please refer to the above mentioned procedure in SET mode.
Step 3: Enter 19 and #, and then the host will warn users through voice message to
delete all informed phone numbers”.
Step 4: Press “#” key again, and then the host will indicate a remote controller
has
has
has
has
been successfully deleted.
②
Command Function: Set Ringing Times by Remote Control
Function Description: “D D” is ringing times (05-15) set to determine when
the alarm host will enter into long distance set-up mode. “D D” must be a 2-digit
number. When ringing times reaches a pre-set value, the alarm host will enter into
long-distance set-up mode. Set-up shall be done according to long distance set-up
table.
Operating Steps: “###”
（
Please enter the preset password
）
+“112233#”
（
The
host enters into adjusting mode
）
+“37#”
（
Please enter ringing times
）
+“09#”
（
The
host gives out a voice prompt “Ding” to indicate ringing times has been successful
set up
）
.
③
Command Function: Set Dialling Times
Function Description: “D D” is dialing cycle number (01-99) and must be a
2-digit number. Dialing cycle refers to a cycle during which the alarm host dials
phone numbers from first to last when an alarm occurs or the system reports the
alarm.
Operating Steps: “###”
（
Please enter the preset password
）
+“112233#”
（
The
host enters into adjusting mode
）
+“38#”
（
Please enter dialling times
）
+“05#”
（
The
host gives out a voice prompt “Ding” to indicate ringing times has been successful
set up
）
.
5.
Set Alarm Sound Volume
①
Command Function: Select on-site alarm volume
Command Grammar: 2 4 # , 2 5 # , 2 6 # , 2 7 #
Function Description:
Press 2 4 # to select the small on-site alarm volume;
