PSI
securing
the luggage compartment trim on the RH side.
Detach the
luggage
compartment weatherseal on the RH side and fold down the trim.
Remove the right-hand rear light cluster. This will enable the Tonneau cover drive mechanism to be seen
while in operation.
5.
Remove the existing bracket, potentiometer and white plastic adapter by the Tonneau cover
them but retain the bracket retaining screw. See Figure 15.A on previous page. Pry off white plastic Piece
with screwdriver.
6.
Remove new potentiometer from new bracket.
7.
Fit the new bracket in place without potentiometer installed and secure it by means of the old bracket’s screw.
See Figure 15.8 on previous page.
8.
Press the new black plastic adapter onto the shaft of the Tonneau cover motor. Fit the key on the inside
the adapter in the groove on the shaft. See Figure
9.
Fit the new potentiometer in place with the electrical leads pointing downwards. See Figure 16.A below.
Be
sure to index “D” shaped slot in potentiometer with adapter.
Figure 16.
Fitting new potentiometer
IMPORTANT
Unless the electrical leads point downwards, the ECM will receive incorrect potentiometer
and the
potentiometer could be damaged beyond repair.
10. Secure the connector by means of a cable tie.
Position the connector as shown in Figure 16.B above.
Page
17 of 24
