PSI
Check the wiring connected to the 5th bow’s potentiometer to make certain it is not too
taut
or too slack. Adjust as necessary.
Parts:
Cable ties (as required)
79 71 880
a ’
(head of Alien bolt
that holds the
gear)
Figure
7. Checking 5th bow potentiometer wirinq
1.
Operate the top using the ‘ROOF” switch until it is in the position shown in Figure 9 above. The top, 5th bow
and the Tonneau cover should be fully raised.
IMPORTANT
The 5th bow must be fully raised for the wiring harness to have the correct amount of slack.
2.
Hook your finger around the wiring and move it downwards. The wiring should be tensioned so that it is
possible to insert the tip of your finger into the hole (Figure 9.A) in the top mechanism.
If necessary, adjust as described below:
a.
Cut the cable tie. See Figure 9.a.
Adjust the length of the wiring harness.
Fasten a new cable tie in place. It should be tightened around the chamfering on the cross-bar so that
cannot slide sideways. See Figure 9.c above.
Page 8 of 24
