900 Convertible Top Troubleshooting Guide
Tonneau cover slams closed
a.
b.
C.
Tonneau cover catches on fabric when closing?
Install rivets as per Customer Satisfaction Campaign 428, item F, page
Remove any stitching previously installed on the elastic straps per earlier PSI
.
Tonneau cover latches not aligned properly?
Readjust latches according to Service Manual
pages 127 128 and re-
program.
See illustration in Step 4 of this guide,
Tonneau motor drive shaft twisted?
If the Tonneau motor drive shaft is twisted, the Tonneau cover may slam
closed. If you think that this situation exists you may have to remove the
joint at the end of the shaft to inspect it for a twist. If the shaft is twisted, you
must replace the Tonneau motor assembly and determine the cause of the
twist. A twisted shaft is usually due to misadjusted Tonneau cover latches.
Make sure the latches are carefully adjusted according to Service Manual
pages 127 128. Make sure to check the Tonneau latch adjustment with
top fully raised, because the 5th bow pushes the Tonneau cover down when
the top is fully raised.
