PSI
0753
T
O
prevent false messages from appearing on
connector HIO-15 for the 5th bow
croswitch must be rewired.
Parts:
Female connecting sleeve
91 20 957
Male connecting pin
41 15077
Cable tie
79 71 880
Connecting pin removal tool
85 80
*Issued as M94 Essential tool. Order from Kent-Moore directly at l-800-345-2233 if necessary.
Figure 9.
Rewiring 5th bow microswitch
NOTE: Some cars have had the wiring modified per instructions included herein but have not had the
switch removed. If upon inspection you can determine that the wiring is correct, remove the
and tape and secure the connector.
1.
Operate the top using the “ROOF” switch until it is in the position shown above. The top, 5th bow and Ton-
neau cover should be fully raised.
2.
Working from the left-hand side, detach the Tonneau cover’s
bag as far as the hinge
and move it out of the way.
3.
Extract connector
O-l 5 and unplug it. See Figure 9.A. Reconnect the pins as described below and on the
following page.
Tonneau cover wiring harness:
4.
Withdraw the yellow/white lead with male pin from position 4 in the female part of connector
5.
Cut off the pin, strip the lead and crimp on a new male pin, P/N 41 15 077.
the
lead
into position 10.
Page 10 of 24
