Ryobi RPH26E, User Manual, Page: 18 / 220

English (Original instructions)
TROUBLESHOOTING
If these solutions do not solve the problem, contact your authorised service dealer.
PROBLEM POSSIBLE CAUSE SOLUTION
(QJLQHZLOOQRWVWDUW 3RZHUVZLWFKLVRII
2. No spark.
3. No fuel.
4. Engine is flooded.
6WDUWHUURSHQRZKDUGHUWRSXOO
WKDQZKHQQHZ
6. Old fuel.
0DNHVXUH6ZLWFKLVLQWKH21RU³
I ” position.
2. The spark plug may be damaged, remove it and check
IRUGLUWDQGFUDFNV5HSODFHZLWKDQHZVSDUNSOXJ
3. Push primer bulb until bulb is full of fuel. If bulb does
not fill, primary fuel delivery system is blocked. Contact
a servicing dealer. If primer bulb fills, engine may be
flooded, proceed to next item.
4. Remove spark plug, turn unit so spark plug hole is aimed
DW WKH JURXQG 6HW FKRNH OHYHU WR
position and pull
VWDUWHU FRUG WR WLPHV 7KLV ZLOO FOHDU H[FHVV IXHO
IURP HQJLQH 5HPRYH DQ\ IXHO ZKLFK VSODVKHG RQ WKH
product. Clean and reinstall spark plug. Clean up any
VSLOOHGIXHODQGPRYHDWOHDVWPDZD\EHIRUHUHVWDUWLQJ
3XOOVWDUWHUWKUHHWLPHVZLWKFKRNHOHYHUDW
. If engine
does not start, set choke lever to position and repeat
normal starting procedure. If engine still fails to start,
UHSHDWSURFHGXUHZLWKDQHZVSDUNSOXJ
5. Contact a servicing dealer.
2QO\XVHIUHVKIXHOPL[HGZLWKUHFRPPHQGHGRLO
Fuel over 30 days old may prevent the unit from
starting.
(QJLQH VWDUWV EXW ZLOO
not idle long enough to
engage throttle
Temperature can effect engine idle
time and rpm.
Flip choke lever to position and pull starter until engine
starts.
Engine does not stop
ZKHQVZLWFKLVWXUQHGRII
Electrical connection is loose/
unplugged
6HWWKHFKRNHOHYHUWR
to stop the engine. Immediately
stop using the product. Check electrical connection on the
bottom of the unit and make sure it is properly connected.
Contact servicing dealer if the problem persists.
(QJLQHVWDUWVEXWZLOOQRW
accelerate.
Engine requires approximately
WKUHHPLQXWHVWRZDUPXS
$OORZHQJLQHWRFRPSOHWHO\ZDUPXS,IHQJLQHGRHVQRW
accelerate after three minutes, contact a servicing dealer.
(QJLQHVWDUWVEXWZLOO
only run at high speed
at half choke. Carburetor requires adjustment. Contact a servicing dealer.
Engine does not reach
full speed and emits
excessive smoke.
1. Check oil fuel mixture.
2. Air filter is dirty.
6SDUNDUUHVWRUVFUHHQLV
dirty.
1. Use fresh fuel and the correct 2-stroke oil mix.
2. Clean air filter. Refer to "Cleaning the air filter screen"
earlier in this manual.
3. Contact a servicing dealer.
16