Ruckus Wireless ZoneFlex 2925/2942 User Guide | Installation, Setup, and Placement of the AP
16
6
Verify that the WAN port LED is lit, along with the activity LEDs on the front of the AP.
7
After a short pause to re-establish the Internet connection, you can test the AP.
1
Using any wireless-enabled computer or mobile device, search for and select the wire-
less network you’ve previously configured.
2
Open a browser and link to any public Web site.
Congratulations! Your wireless network is active and ready for use.
Troubleshooting the Initial Setup Connection
If the startup sequence doesn’t work, verify that the network name (SSID) and security set-
tings on the AP match your wireless network.
• Disconnect the AP from the power source, wait 5 seconds, then reconnect it—and wait 60
seconds before attempting a reconnection.
• Disconnect and reconnect the AP and the PC.
• Replace the Ethernet cable with a new one if the relevant LAN port LED is not illumi-
nated. (LEDs in each port light up during a successful connection.)
If all else fails, you can reset the AP to the factory defaults (and start over).
1
Insert a straightened-out paper clip into the reset button hole (located on the back of
the AP.)
2
Press and hold the Reset button for at least eight (8) seconds.
3
You can now reconnect your PC directly to the AP (as described on
“Connecting the AP
to your PC”
on page 10) and start over with installation, using the default network set-
tings.
7
Testing the newly placed AP
