RTS RVON-I, User Manual

Page: 33 / 40

29
RVON-I/O Command Table
All are “set channel #” commands because they are for each audio channel.
Set Serial
When using Serial Pass-Through Mode, you must set the serial port you will use with the IP Address for the destination serial
pass-through port you are going to use. You must also set the baud rate at which data will be transmitted over the serial port
(DIP Switch 2 OPEN). For more information on DIP switches, see “DIP Switches” on page 5.
Set GPIO
When configuring the GPI/O on the RVON-I/O, there are three different mode options you may choose:
Pass-Through Mode for GPI/O: In Pass-Through mode, GPI/O status is sent over Ethernet, therefore you must set the IP
Address of the destination GPI/O pass-through port.
1 Keypanel (Single Port) Mode :In 1 Keypanel mode, also referred to as single port mode, all GPI/O on the RVON-I/O are
associated with only one keypanel. Associating the GPI/O with a keypanel allows you to access/address the GPI/O in UPL
Statements. Use the Set Panel parameter to designate which RVON-I/O port is associated with all the GPI/O’s on the unit.
1 KEYPANEL MODE EXAMPLE
The GPI/O is associated with Port 0. This means that Port 0 will have eight GPI/O’s mapped to it. Connected to Port 0 is a
keypanel with the keypanel ID of 33 in AZedit. To use the GPI/O, you can create UPL statements. But be careful to assign the
correct Output Action parameters.
COMMAND DEFAULT VALUE DESCRIPTION
dest_ip 0.0.0.0 Destination IP Address for this particular channel.
dest_type 0 Destination type X = 0 (rvon-8), 1 (rvon-1), 2 (rvon-I/O)
dest_chan 0 Destination channel - the port on the far end (0-7)
chan_codec 0 Profile to use (previous coding table).
Table 12.