RTS RVON-I, User Manual

Page: 25 / 40

21
Setup IP Addresses
8.
At the prompt, type dbgcmd to access the debug command screens.
9.
Press Enter .
An MXP prompt appears .
10.
At the MXP prompt, type set rvon ip_addr 10.3.210.12 (this IP Address is for example purposes only).
11.
Press Enter .
The IP Address is set for the RVON-I/O .
12.
Set the Netmask .
13.
At the MXP prompt, type Activate .
RVON-I/O will reset itself to the new IP Address. The current telnet session becomes invalid .
Configure the IP Address Using the Serial Debug Port
NOTE : In order to use the Serial Debug Port to set the IP Address for your RVON-I/O, you must know the intended IP
Address. Also, you must make sure DIP switch 2 is not enabled (CLOSED).
The following instructions will show you how to access the Serial Debug Port screens and show you how to configure the IP
Address for the RVON-I/O
To configure the IP Address for the RVON-I/O, do the following:
1.
Connect the PC’s COM port to the RVON-I/O’s serial connector.
2.
Run a HyperTerminal program.
The window provided Hyper Terminal is located at Start Programs > Accessories>Communications >HyperTerminal.
3.
At the prompt, type dbgcmd .
Figure 4.