RTS RVON-I, User Manual

Page: 14 / 40

Installation
10
7.
Once you are finished configuring the RVON-I/O, type ACTIVATE into the command prompt to activate the
configuration setup on the RVON-I/O.
NOTE : If you do not have a RVON-1 pre-installed, the KP-32 or the KP-812 must have the RVON-1 component
installed prior to Remote setup (See the RVON-1 User Manual for details).
RVON-I/O Trunk Setup
When trunking two intercom systems over Ethernet using RVON-I/O, you can setup the RVON-I/O on both ends
of the trunks in either
LOCAL or REMOTE mode. However, a REMOTE to REMOTE mode system is the
preferred way of trunking.
To setup remote mode in a trunked system, do the following:
1.
On the back of the RVON-I/O, put DIP switch 1 in the CLOSED position (Remote Mode).
2.
Power ON the RVON-I/O unit.
3.
Connect the Matrix to the RVON-I/O (via I/O ports), using a DB-9 crossover cable. See page 6 for the
different connection diagrams.
4.
Connect the RVON-I/O to Ethernet .
5.
Set the IP Address for the RVON-I/O (see “Setup IP Addresses” on page 17).
6.
Using Telnet or Serial programming, configure the RVON-I/O as follows:
set channel [chan]
dest ip_addr (IP Address of the RVON-1, RVON-8, or RVON-I/O that is connected to
the RVON-I/O)
dest_type (the type of device, either an RVON-1, RVON-8, or RVON-I/O)
dest_chan
dest_codec
set panel [panel]
poll_id (see “Set Panel” on page 30)
NOTE: If the RVON-I/O is in Remote Mode, set the Panel Poll ID to 0, so it will not
be seen as keypanel.
baud
NOTE : To see actual Telnet commands, see “RVON-I/O Command Table” on page 25.
7.
Once you are finished configuring the RVON-I/O, type ACTIVATE into the command prompt to activate the
configuration setup on the RVON-I/O
NOTE : To set up the other side of the trunk system, repeat steps 1 through 7.