RTS RVON-I, User Manual

Page: 21 / 40

17
CHAPTER 3
Configuration
Setup IP Addresses
There are three ways in which the IP Address can be set on the RVON-I/O; via a keypanel , through Telnet , or using the Serial
Debug Port .
If you are using a keypanel to set the IP Address of the RVON-I/O, you must use a KP-32, KP-632, KP-832, or a KP-812.
There are two sets of instructions to configure the IP Address from a KP-32, KP-632, KP-832 and a KP-812. This is because
the KP-812 uses encoder knobs to navigate its menu system. For instructions on how to use the KP-812 to configure the IP
Address, see “Configure the IP Address from a KP-812” on page 18.
Configure the IP Address from a KP-32, KP-632, or a KP-832
NOTE : Make sure DIP switch 1 is in the OPEN position (LOCAL mode - LED 24 RED is NOT lit). Also, make sure DIP
switch 2 is in the CLOSED position (configuration via IO port 8 enabled).
To configure the IP Address from a KP-32, KP-632, KP-832 keypanel, do the following:
1.
Connect the RVON-I/O using serial cable from the IO port 8 on the unit to the FRAME connector on the KP-32, KP-632,
or KP-832.
NOTE : The firmware on the KP-32, KP-632, KP-832 keypanels needs to be at version 2.0.2 or higher.
2.
On the KP-32, KP-632, and KP-832, press Menu .
The Display menu item appears.
3.
Press the up arrows or down arrows to scroll to Service.
4.
Press PGM .
The Aux Inputs menu item appears .
5.
Press the up arrows or down arrows to scroll to RVON Setup.
6.
Press PGM .
The IP Address menu item appears .
7.
Press PGM .
The current IP Address appears .
8.
Enter the first number in the IP Address.
This activates the first octet of the IP Address and clears the rest of the IP Address .
9.
Press PGM .
This confirms the first octet in the IP Address and moves you to the second octet .