RTS RVON-I, User Manual

Page: 13 / 40

9
Basic Local Mode Setup
Basic Local Mode Setup
NOTE : Keypanel version is not relevant in Local Mode.
In LOCAL mode, the keypanel is directly connected to the RVON-I/O through the use of a DB-9 serial cable.
To setup an RVON-IO local mode system, do the following
1.
On the back of the RVON-I/O, put DIP switch 1 in the OPEN position (LOCAL mode).
2.
Power ON the RVON-I/O unit.
3.
Connect keypanels to the RVON-I/O (I/O ports), using a straight DB-9 (serial cable). See page 6
4.
Connect the RVON-I/O to the Ethernet .
5.
Set the IP Address for the RVON-I/O (see “Setup IP Addresses” on page 17).
6.
Using Telnet or Serial programming (see “RVON-I/O Command Table” on page 25), configure the RVON-I/O as
follows:
NOTE : To see actual Telnet commands, see “RVON-I/O Command Table” on page 25
set channel [chan]
dest ip_addr (IP Address of the RVON-1, RVON-8, or RVON-I/O that is connected to the RVON-I/
O)
dest_type (the type of device, either an RVON-1, RVON-8, or RVON-I/O)
dest_chan
dest_codec (optional)
7.
Once you are finished configuring the RVON-I/O, type ACTIVATE into the command prompt to activate the
configuration setup on the RVON-I/O
Basic Remote Mode Setup
In Remote Mode, the keypanel with RVON-1 installed is directly connected to the RVON-I/O via Ethernet.
To setup a basic remote mode system, do the following:
1.
On the back of the RVON-I/O, put DIP switch 1 in the CLOSED position (Remote Mode).
2.
Power ON the RVON-I/O unit.
3.
Connect the matrix system to the RVON-I/O (I/O ports), using a DB-9 crossover cable. See page 6 for the different
connection diagrams.
4.
Connect the RVON-I/O to Ethernet .
5.
Set the IP Address for the RVON-I/O (see “Setup IP Addresses” on page 17).
6.
Using Telnet or Serial programming (see “RVON-I/O Command Table” on page 25), configure the RVON-I/O as follows.
NOTE : To see actual Telnet commands, see “RVON-I/O Command Table” on page 25.
set channel [chan]
dest ip_addr (IP Address of the RVON-1, RVON-8, or RVON-I/O that is connected to the RVON-I/
O)
dest_type (the type of device, either an RVON-1, RVON-8, or RVON-I/O)
dest_chan
dest_codec (optional)
set panel [panel]
poll_id (see “Set Panel” on page 30)
baud