Roto E-Tec DoorDrive, Installation, Maintenance And Operation Instructions

Page: 24 / 52

24

May 2013

IMO_294_EN_v0 Roto E-Tec DoorDrive Subject to change.
15.
Connect the second plug-and-socket connector X2
to cable type S as per Table 2 (similar to first plug-
and-socket connector).
Table 2: Assignment of plug-and-socket connector X2
to house wiring / lock to cable type SD
Contact Description Abbreviation Wire colour
1
Lock signal SSIG
2
Lock ground SGND
3
Lock supply S+
4
Lock feedback SRM
5
Driver output OFF
6
Antenna ANT
7
Signal 1 IN1 Pink
8
Signal 1 AC IN1AC
9
Signal 2 / IN2 Blue
10
Signal 3 IN3
11
Supply voltage 12V Red
12
Ground GND Black
Connect cable – using screwdriver (2.5 x 0.4 mm).
To jam the plug-and-socket connector in place, insert a
screwdriver at an incline onto the outer visible spring in
the terminal strip. The screwdriver opens the spring
contact and sticks there in place (it can then be
released).
Insert the wire and remove the screwdriver again. The
contact numbering is printed on to the side.
The two connectors are coded and they cannot be
interchanged. Therefore, when connecting the lines
make sure that the correct plug-and-socket connector
has been selected.
Installation
Installation steps