00-00-00
Effectivity 912/914 Series
Edition 1 / Rev. 3
page 27
October 01/2010
d04774
BRP-Powertrain
Maintenance Manual
8) Technical documentation
See also the corresponding Maintenance Manual (Line Maintenance) for the re-
spective engine type 912 Series or 914 Series.
8.1)
Filling in the dimension sheets
See Fig. 00-1
All measurements must be entered in the corresponding dimension sheets as
shown.
Fig. 00-1 shows the correct procedure for filling in the dimension sheets attached
after each section.
■
CAUTION: If the engine is overhauled / repaired before the end of the TBO,
the 50% specified values (3) for wear limits do not apply and
must be calculated separately in accordance with Section 9
“Classification of parts for maintenance”.
- Look up the desired control point code (1) in the illustration in the specified
section.
- The maximum limits for wear are divided into two columns, maximum wear
100% (2) and 50% wear (3).
- Field (4) gives the maximum permissible values in [mm], field (5) in
[inches].
- The respective actual value must be entered in the corresponding box (6)
in [mm] or [inches].
- The actual value for any part which has been replaced is entered in the
corresponding field (7) in [mm] or [inches].
1
2
3
4
5
6
7
07538
Fig. 00-1
Summary of Contents for MMH-912 Series
Page 463: ......
